Earthquake-prone buildings

It ensures the way our buildings are managed for future earthquakes is consistent across the country, and provide more information for people using buildings, such as notices on earthquake-prone buildings and a public register.

Read more information about managing earthquake-prone buildings on MBIE's Building Performance website.

A building, or part of a building, is earthquake prone if it will have its ultimate capacity exceeded in a moderate earthquake, and if it were to collapse would do so in a way that is likely to cause injury or death to persons in or near the building or on any other property, or damage to any other property.

Territorial authorities (TA) determine if a building or part of a building is earthquake prone using the earthquake-prone buildings (EPB) notice methodology, a document that sets out how territorial authorities identify potentially earthquake-prone buildings, how engineers undertake engineering assessments and how territorial authorities determine whether a building or part is earthquake prone, and if it is, its earthquake NBS% (national building standards percentage) rating.

The methodology to identify earthquake-prone buildings can be found here.

The Whanganui District is within the medium seismic zone.

What are the timeframes for identifying and strengthening in the medium seismic zone?

The timeframes for the medium seismic zone are:

The following profile categories apply to the Whanganui District: 

Priority buildings are certain types of buildings in high and medium seismic-risk areas that are considered to present a higher risk because of their construction, type, use or location. They need to be identified and remediated within half the time allowed for other buildings in the same seismic-risk areas. The Building Act s133AE also prescribes specific buildings as a priority building and they include:

• Hospital buildings that are likely to be needed to provide emergency medical and ancillary services in an emergency
• Buildings that are likely to be needed as an emergency shelter or an emergency centre in an emergency; or that enable emergency response services to carry out their jobs in an emergency
• Buildings that are used for education purposes that are regularly occupied by at least 20 people.

Other buildings or parts of buildings that could be considered priority buildings include:

• Parts of unreinforced masonry (URM) buildings that could fall in an earthquake onto thoroughfares with sufficient vehicular or pedestrian traffic. This can include parapets, verandas, balconies and decorative ornaments attached to the façade
• Buildings that could impede transport routes of strategic importance (in terms of emergency response) if they were to collapse in an earthquake

A Priority thoroughfare is deemed to be an area with high pedestrian and vehicle movements. The community has been consulted to identify these thoroughfares. 

A Priority route is one that is deemed to be one of strategic importance that, if impeded may lead to an inability to provide an emergency response.

EQPB - Priority Thouroughfares and Routes(PDF, 1MB)

Whanganui District Council must report to the Chief Executive of MBIE every two years to supply updates on progress for both identifying and the remediation of EPBs. The council's first report is due by 1 July 2019.

Once the new record keeping systems (national and local) are in place, council officers will begin the process of profiling potential EPBs in 2018. The public submission process for priority thoroughfares and priority routes may impact upon timeframes.

The council will advise the public accordingly when officers begin the EPB profiling project.

The council will review the existing Initial Evaluation Procedure (IEP) reports it has on file and make a decision on their status as per the new EPB methodology.

You'll need to contact council to ascertain if your building meets any of the new categories for EPBs. If the building meets the EPB category criteria you can supply the council with your IEP report. The council will moderate this report against the EPB methodology and make a decision around suitability. 

The council will advise you of the decision and will accept the report or you'll need to contact your engineer and organise either an initial seismic assessment (ISA) or detailed seismic assessment (DSA) to meet the new EPB methodology.

An ISA is an Initial Seismic Assessment which is the first step of a Detailed Seismic Assessment and is produced by an engineer. This can be submitted to the council as evidence of a building's NBS%.

A DSA is a Detailed Seismic Assessment and is a comprehensive seismic report supplied by an engineer. This can be submitted to the council as evidence of a building's NBS%.

A rating given to a building expressed as a percentage of New Building Standard (NBS%) achieved. This is based on an assessment of the expected seismic performance of an existing building relative to the minimum required under the Building Code to a new building on the same site with respect to safety of life.

If the council has identified the building as a potential EPB, we will advise you of the decision. You'll then need to contact your engineer and organise either an ISA or DSA to meet the new EPB methodology.

You'll have 12 months from when the council contacted you to supply this report. You can apply to the council for an extension of this 12-month timeframe but you must do this no later than two months before the original timeframe due-date.

The council will assess the report and either request further information or accept the findings, and document its decision. 

The council must promptly issue an EPB notice when a building or part of a building has been identified as earthquake prone. The EPB notice must be in the prescribed form, dated, identified if whole or part of building is an EPB, specify if it is a priority building and specify the NBS% and the timeframes for remediation.

Once the appropriate decisions have been made and recorded of a building or part of a building's status then the council must also update the national register of earthquake-prone buildings (the EPB register).

If the reports confirm that the building or parts of the building are not considered earthquake prone then the building owner will be advised accordingly and this information will be stored on the property file.

Yes, you can – however, you can only apply for an exemption after the council has issued the EPB notice. 

The council can prescribe a fee for this service.

A building owner of a Category 1 or 2 Heritage New Zealand-listed building may apply for an extension of time to carry out seismic work.

An application can only be made once a building has been identified as an EPB and an EPB notice has been issued. The application for an extension must be in writing.

There is the potential for the council to grant a 10-year extension if the Heritage New Zealand criteria is met.

The council can prescribe a fee for this service.

There are two categories of ratings for earthquake-prone buildings prescribed in the regulations. These categories determine which form of EPB notice is issued by the council:

• 0% to less than 20%
• 20% to less than 34%

Once the council issues and attaches the appropriate EPB notice it must be displayed in a prominent place on or adjacent to the building.

If an EPB notice ceases to be attached to the building or an EPB notice becomes illegible the building owner must contact the council and advise of the circumstance.

The council will then issue a new EPB notice.

The council can issue a $1000 infringement fee or on conviction, a fine of $20,000 if a building owner fails to comply with the requirement to attach an EPB notice or exemption notice, or failing to notify the territorial authority when a notice becomes illegible.

Yes, you can – however, once an EPB notice has been issued to a building any substantial alterations will trigger the requirement to carry out seismic work before the EPB notice deadline.

When the council receives a building consent for work on a building that has been identified as earthquake prone it must consider the substantial alteration criteria of the EPB methodology. Together with other work consented in the past two years, has an estimated value of at least 25% of the buildings value and is more than $150,000.

A building consent is processed as per standard S112 requirements and must address:

• Means of escape from fire
• Access and facilities for people with disabilities.

If the building work triggers a Change of Use then there is a requirement that the building will be upgraded to meet all parts of the current building code as near as reasonably practicable.

A building owner can undertake seismic work only on a building or part of a building which has an EPB notice without having to address: 

• means of escape from fire
• access and facilities for people with disabilities.

A building consent is required and must clearly outline the scope of work.

Building owners who fail to complete seismic work within the specified time frame on an EPB notice can be either be issued an infringement notice for $1000, or a fine of up to $200,000, if convicted. 

The council may carry out any seismic work if the requirements of an EPB notice are not completed by the deadline applied to that particular building or part of building.

The council can apply to the Whanganui District Court authorising the council to carry out seismic work. Costs can be passed to the building owner.

The seismic work can also include the demolition of the building or parts of the building.